Smarter Tools STSG-800G Manuale di Manutenzione e Cura Scaricare il pdf (Pagina 10)

3. Turn fluid control knob fully clockwise until closed (See Figure 6).

4. Trigger a short burst while turning fluid

control knob counterclockwise. Observe

the spray pattern on the target and

adjust the fluid control knob until the

desired pattern (atomization) is obtained

(See Figure 7).

If the spray is too fine (excessive over-spray), caused by too much

air for the amount of paint being sprayed, reduce the air pressure or

open the fluid control to spray more material.

If the spray is too coarse (spitting globs), reduce the amount of

material with the fluid control knob or thin the paint.

5. The fluid control knob can be used to finely adjust pattern

consistency.

Before spraying the work-piece, practice a few minutes on a cardboard target to

ensure the pattern size and consistency are set correctly.

Operation

1. Begin spraying. Always keep the gun at right angles

to the work (See Figure 8).

2. Keep the nozzle about 6 to 9 inches from the work

surface throughout the stroke and always keep the

gun in motion while spraying. Stopping gun

movement in mid-stroke will cause a build-up of paint

and result in runs. Do not fan the gun from side to

side while painting. This will cause a build-up of paint

in the center of the stroke and an

insufficient coating at each end (See

Figure 9).

3. Trigger the gun properly. Start the gun

moving at the beginning of the stroke

BEFORE SQUEEZING THE TRIGGER

and release the trigger BEFORE

STOPPING GUN MOVEMENT at the

end of the stroke. This procedure will

feather (blend) each stroke with the

next without showing overlap or

unevenness (See Figure 10).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Nessun commento

Smarter Tools STSG-800G Manuale di Manutenzione e Cura Pagina 10